Xaircraft X450 Pro Manuel d'utilisateur télécharger pdf (Page 20)

地面摇杆操作测试后，进行传感器工作状态测试。

1 拔出飞行模式选择通道的连接线。

2 将遥控器油门收到最小后打开遥控器开关。

3 X450 Pro接通电源。

4 半蹲姿势，左手抓紧X450 Pro的底部，举到前上方，高度高于头顶。

5 右手轻推油门至20%的杆量。

6 尝试使用左手使飞行器前、后、左、右倾斜，感觉飞行器是否阻止您使飞行器倾斜。

7 如果飞行器没有阻止您使它倾斜，则将油门收到最小，断开X450 Pro电源，重新检查电路

安装（如AHRS的安装方向是否正确，连接线是否接好）后再次测试。

8 如果飞行器的反应正确，将油门推最小，断开X450 Pro的电源，就可以进行首次试飞了。

（默认为Input5）

姿态传感器工作状态测试 AHRS Function Test

After X450 Pro stick function test on ground now it goes sensor test.

1 Unplug Flight Mode channel signal cable (default Input 5).

2 Throttle down to lowest then turn on the transmitter.

3 Power on X450 Pro.

4 Squat and grasp the bottom side of X450 Pro to lift it higher than your head.

5 Apply throttle slowly to 20%.

6 Try to bank the aircraft forwards, backwards, left side and right side and feel it

whether aircraft has stopped your moving.

7 If no resistance, throttle down to lowest and power off X450 Pro.Check if

electronic parts installs properly.(Like AHRS installation orientation or good

connection).Then test again.

8 If aircraft reacts perfect, throttle down to lowest and power off X450 Pro.Now

you can start your first fly and enjoy it.

测试时请注意安全，避免被螺旋桨击中。

Pay attention to rotating blades from getting hurt.

1 2 ... 15 16 17 18 19 20 21 22

Pas de commentaire

Xaircraft X450 Pro Manuel d'utilisateur Page 20